Prospective changes in irrigation water requirements caused by agricultural expansion and climate changes in the eastern arc mountains of Kenya

Water resources and land use are closely linked with each other and with regional climate, assembling a very complex system. The understanding of the interconnecting relations involved in this system is an essential step for elaborating public policies that can effectively lead to the sustainable use of water resources. In this study, an integrated modelling framework was assembled in order to investigate potential impacts of agricultural expansion and climate changes on Irrigation Water Requirements (IWR) in the Taita Hills, Kenya. The framework comprised a land use change simulation model, a reference evapotranspiration model and synthetic precipitation datasets generated through a Monte Carlo simulation. In order to generate plausible climate change scenarios, outputs from General Climate Models were used as reference to perturbing the Monte Carlo simulations. The results indicate that throughout the next 20 years the low availability of arable lands in the hills will drive agricultural expansion to areas with higher IWR in the foothills. If current trends persist, agricultural areas will occupy roughly 60% of the study area by 2030. This expansion will increase by approximately 40% the annual water volume necessary for irrigation. Climate change may slightly decrease crops' IWR in April and November by 2030, while in May a small increase will likely be observed. The integrated assessment of these environmental changes allowed a clear identification of priority regions for land use allocation policies and water resources management.     

Monitoring the multi-year carbon balance of a subarctic palsa mire with micrometeorological techniques

This article reports a dataset on 8 years of monitoring carbon fluxes in a subarctic palsa mire based on micrometeorological eddy covariance measurements. The mire is a complex with wet minerotrophic areas and elevated dry palsa as well as intermediate sub-ecosystems. The measurements document primarily the emission originating from the wet parts of the mire dominated by a rather homogenous cover of Eriophorum angustifolium. The CO(2)/CH(4) flux measurements performed during the years 2001-2008 showed that the areas represented in the measurements were a relatively stable sink of carbon with an average annual rate of uptake amounting to on average -46 g C m(-2) y(-1) including an equally stable loss through CH(4) emissions (18-22 g CH(4)-C m(-2) y(-1)). This consistent carbon sink combined with substantial CH(4) emissions is most likely what is to be expected as the permafrost under palsa mires degrades in response to climate warming.     

Metal pollution does not bias offspring sex ratio in great tit (Parus major)

Purpose

We measured offspring sex ratios in a resident insectivorous passerine bird, the Great tit Parus major, to find out whether metal pollution around a Finnish copper smelter would bias sex ratios in this territorial forest bird species. Besides a direct effect of pollutants, we were interested in possible indirect effects of pollution-related resource limitation, i.e., changes in food quality and quantity, on sex ratio.

Methods

We manipulated the diet quantity and quality (carotenoid levels) of P. major nestlings in polluted and unpolluted environments to find out if variation in dietary resource levels has any effect on fledgling sex ratios. Faecal metal levels of nestlings were analysed to monitor the level of pollution exposure at each territory. Near the time of fledging (at the age of 15 days), feather samples were collected for molecular sex determination.

Results

We did not find any association between metal exposure levels and offspring sex ratio, and thus, our results do not support the hypothesis that metal pollution would have direct effects on P. major offspring sex ratio. We found that, irrespective of pollution level, high nestling mortality was associated with male-biased sex ratio, most likely due to sex-specific mortality. Our feeding treatment, however, showed no significant effects on offspring sex ratio, possibly because natural variation in food availability outweighed the effect of our food manipulation on nestling mortality.

Conclusions

We conclude that metal exposure at the levels found in our study area does not bias fledgling sex ratios in this species, but biased sex ratios may follow under natural or pollution-related resource limitation.     

Degradation of 1,2-dichloroethane from wash water of ion-exchange resin using Fenton’s oxidation

Background, aim, and scope  

Chlorinated volatile organic compounds (CVOCs), widely used in industry as solvents and chemical intermediates in the production of synthetic resins, plastics, and pharmaceuticals, are highly toxic to the environment and public health. Various studies reported that Fenton’s oxidation could degrade a variety of chlorinated VOCs in aqueous solutions. In acidic conditions, ferrous ion catalyzes the decomposition of H₂O₂ to form a powerful ^•OH radical. In this study, wastewater from wash of ion-exchange resin containing typical CVOC, 1,2-dichloroethane, was treated using Fenton’s oxidation. To reduce environmental load and processing costs of wastewater, Fenton process as a simple and efficient treatment method was applied to degrade 1,2-dichloroethane of wash water.     

Water quality in the Tibetan Plateau: metal contents of four selected rivers

The water used by 85% of the Asian population originates in Tibetan Plateau. During April and May of 2006, water samples were collected from four major Asian rivers in the Plateau (i.e. the Salween, Mekong, Yangtze River and Yarlung Tsangpo) and analyzed for Cu, Pb, Zn, Ag, Mo, Cd, Co, Cr, Ni, Li, Mn, Al, Fe, Mg and Hg. The results showed that elements such as Mg were rather high in Tibetan rivers, giving a mean electrical conductance of 36 mS/m. In a few locations, the results also showed relatively high concentrations of Al and Fe (>1 mg/L). However, the concentrations of Cu, Zn, Ag, Cd, and Cr were generally low. Contamination with Pb was identified at a few locations in the Salween and Ni at a few sites in the Yangtze River.     

Ultraviolet light-emitting diodes in water disinfection

Background, aim, and scope  The novel system of ultraviolet light-emitting diodes (UV LEDs) was studied in water disinfection. Conventional UV lamps, like mercury vapor lamp, consume much energy and are considered to be problem waste after use. UV LEDs are energy efficient and free of toxicants. This study showed the suitability of LEDs in disinfection and provided information of the effect of two emitted wavelengths and different test mediums to Escherichia coli destruction. Materials and methods  Common laboratory strain of E. coli (K12) was used and the effects of two emitted wavelengths (269 and 276 nm) were investigated with two photolytic batch reactors both including ten LEDs. The effects of test medium were examined with ultrapure water, nutrient and water, and nutrient and water with humic acids. Results  Efficiency of reactors was almost the same even though the one emitting higher wavelength had doubled optical power compared to the other. Therefore, the effect of wavelength was evident and the radiation emitted at 269 nm was more powerful. Also, the impact of background was studied and noticed to have only slight deteriorating effect. In the 5-min experiment, the bacterial reduction of three to four log colony-forming units (CFU) per cubic centimeter was achieved, in all cases. Discussion  When turbidity of the test medium was greater, part of the UV radiation was spent on the absorption and reactions with extra substances on liquid. Humic acids can also coat the bacteria reducing the sensitivity of the cells to UV light. The lower wavelength was distinctly more efficient when the optical power is considered, even though the difference of wavelengths was small. The reason presumably is the greater absorption of DNA causing more efficient bacterial breakage. Conclusions  UV LEDs were efficient in E. coli destruction, even if LEDs were considered to have rather low optical power. The effect of wavelengths was noticeable but the test medium did not have much impact. Recommendations and perspectives  This study found UV LEDs to be an optimal method for bacterial disinfection. The emitted wavelength was found to be an essential factor when using LEDs; thus, care should be taken in selecting the proper LED for maximum disinfection.     

Removal of dichloromethane from ground and wastewater: A review

Dichloromethane (DCM) is a toxic volatile compound which is found in the ground waters and wastewaters of the pharmaceutical, chemical, textile, metal-working and petroleum industries. DCM inhibits the growth of aquatic organisms, induces cancer in animals and is potentially carcinogenic for humans. This article aims to review existing water treatments for DCM removal, focusing on recent technological advances. Air stripping, adsorption and pervaporation were found to be effective in separating DCM from water with a process efficiency of about 99%, 90% and 80% respectively. Electrocatalysis over Cu-impregnated carbon fiber electrode, photo irradiation over TiO₂ and photo-Fenton process led to the complete decomposition of DCM. Aerobic and anaerobic water treatment achieved 99% and 95% removal of DCM respectively. The maximum efficiencies observed for acoustic cavitation, radiolysis and catalytic degradation of CH₂Cl₂ were 90%, 92% and 99% respectively. Ozonation and persulfate oxidation showed lower DCM degradation efficiencies, not exceeding 20%. Further combination of different water treatment methods will further increase DCM degradation efficiency.     

Degradation of chelating agents in aqueous solution using advanced oxidation process (AOP)

This article presents an overview with critical analysis of technical applicability of advanced oxidation process (AOP) in removing chelating agents from aqueous solution. Apart from the effect of metals for chelating agents as a major influencing factor, selected information such as pH, oxidant’s dose, concentrations of pollutants and treatment performance is presented. The performance of individual AOP is compared. It is evident from our literature survey that photocatalysis with UV irradiation alone or coupled with TiO₂, ozonation and Fenton’s oxidation are frequently applied to mineralize target pollutants. Overall, the selection of the most suitable AOP depends on the characteristics of effluents, technical applicability, discharge standard, regulatory requirements and environmental impacts.     

Microbial activities in soils of a former sawmill area

To find out microbial metabolic functioning and toxicity in a former sawmill area, carbon dioxide evolution, methane oxidation potential, 10 hydrolytic enzyme activities, Vibrio fischeri test, fluorescein diacetate hydrolysis activity (FDA), soil pH, carbon, nitrogen and pentachlorophenol (PCP) content were measured at four sites. The area is contaminated with aged chlorophenols. Chlorophenol content of soil was analyzed with a novel HPLC-MS technique, which allowed to measure chlorophenols without derivatization. The sites had a pollution gradient from 0.5 to 15 microg PCP g dw of soil(-1). Endogenous carbon dioxide evolution, methane oxidation potential, butyrate-esterase, acetate-esterase, sulphatase and aminopeptidase activities were lower at the site 2 than 3, although the site 2 and 3 had similar content of carbon and nitrogen. The soil was toxic in V. fischeri test at the site 2, which had high content of PCP (3.93+/-1.00 microg PCP g dw of soil(-1)). The results indicated that endogenous carbon dioxide evolution, methane oxidation potential, butyrate-esterase, acetate-esterase, sulphatase and aminopeptidase activities were sensitive to PCP in the soil. The results indicated that alpha-glucosidase, beta-glucosidase, beta-xylosidase, beta-cellobiosidase, phosphomonoesterase, N-acetyl-glucosaminidase activity and FDA hydrolysis activity were not sensitive to PCP in the soil. Soil processes involved in the cycling of carbon, nitrogen, sulphur and phosphorus were only slightly vulnerable in the former sawmill area and most sensitive microbial species were probably replaced with more tolerant ones to maintain and recover functioning of the former sawmill soils.